CAME MTMA/01, Programming Manual

Page: 7 / 8

a a
b b
3 8
4
6
9
7
5
2
1
100 °
82 °
54 °
72 °
1÷9
0
a a
b b c c
Pa
ge
7
- M
an
ua
l
FA
01
47
9-
EN
- 0
7/
2
0
2
0 - © C
A
M
E S
.p.
A
. - T
he c
on
te
nt
s o
f t
hi
s m
an
ua
l m
ay b
e c
ha
ng
ed
, a
t a
ny t
im
e, a
nd w
ith
ou
t n
ot
ic
e. - T
ra
ns
la
tio
n o
f t
he
or
igin
al
ins
tr
uc
tio
ns
Adjusting the brightness and colour of the module
backlight
During call programming
a a
, you can control the brightness
and colour of the unit backlight. Press the left call button to select
white
b b
, and the right call button to select blue
c c
.
Press the same button repeatedly to select one of the fi ve bright-
ness levels (off , 25%, 50%, 75%, 100%).
Programming the entry panel video camera
While programming the calls, the video camera’s fi eld of view can be adjusted from any
receiver. To do this, lift the handset (where present) and press the “auto-connection
”
button . From the default confi guration, scroll through the subsequent confi gurations
pressing the AUX1 button or go back to the previous confi gurations by pressing the
AUX2 button . Settings are saved automatically.
Adjusting the brightness level of the light on the entry panel
While programming calls a a , the brightness level of the entry panel light can be adjust-
ed from any receiver. Press the “auto-connection ” button on the internal receiver
b b
to activate the video camera on the entry panel for which you want to adjust the brightness
level. Use a previously assigned call button to increase/decrease brightness of the light
.
Reprogramming
When reprogramming a system which has already been programmed, you are taken directly to call programming. To access button
reprogramming, follow the process for forcing the mode switch described above.
If you add, replace or remove an entry panel, you must follow the “programming buttons” procedure so that the system recognises the
changes.
RESTORING FACTORY SETTINGS
To restore the entry panel to the default settings (including the terminal functions
,
), remove the power supply, press and hold
the two call buttons on the unit and power the device.
After 5 seconds the entry panel restarts.
NOTE: if the entry panel does not restart, it has not been restored to factory settings.
The product complies with the relevant directives in force.
Dismantling and disposal. Dispose of the packaging and the device responsibly at the end of its life cycle, in compliance with the laws
in force in the country where the product is used. The recyclable components are marked with a symbol and the material ID marker.
THE DATA PRESENTED IN THIS MANUAL MAY BE CHANGED, AT ANY TIME, AND WITHOUT NOTICE.
MEASUREMENTS, UNLESS OTHERWISE STATED, ARE IN MILLIMETRES.