7
T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n s
h
ow
n i
n
t
h
is
d
ia
lo
g
u
e m
ay b
e c
h
an
g
ed by C
am
e C
an
ce
ll
i A
u
to
m
at
ic
i S
.p
.A
. a
t a
n
y t
im
e w
it
h
o
u
t p
ri
o
r w
ar
ning
.
ENGLISH
6.1 Adjusting the brake microswitches
Fig. 7
Fig. 6
– Using the motor, make so that the gate leaf is max 500mm from being fully opened.
At this point do a fi rst adjustment of the (endstop) microswitches, positioning them close to the magnet. Consider that this type of
endstop reads the magnetic fi eld. You may have to repeat the procedure to increase the precision of the adjustment (fi g. 6/7);
6.2 Adjusting the limit stop’s stopping zone
Prepare a 60x30 mm template - and hold it up against one of the two mechanical stops as shown in fi g. 8 (adjustment is to be
made either on the closing endstop or opening endstop).
Activate the gate - either using a command button or the remote control - and turn the OP TIME (TL) trimmer clockwise until the
gate leaf inverts its direction just as it touches the obstacle/template.
Then turn the template from its short side (fi g. 9) and check that the gate leaf stops against the obstable/template. Otherwise
activate the trimmer clockwise.
Fig. 8
Fig. 9
A =Effective range of the motion-inverter amperometric sensor.
B =Run zone at normal speed.
C =Run zone at slow speed.
D =Effective range of the motion-stop amperometric sensor
E =
Opening/Closing position mechanical gate stops
Microswitch
Endstop
holding plate
Magnet
Microswitch
