(mm)
9
3
4
2
5
6
7
10
11
1
2
8
ENGLISH
p.
4
-
M
an
u
al
c
od
e:
11
9
B
F
0
3
11
9
B
F
0
3
ve
r.
2
04/2
0
14
© 0
9
/2
0
10 © C
A
M
E c
an
ce
lli
A
uto
m
ati
ci
S
.p.
A
. - T
h
e d
ata a
n
d i
nf
or
m
ati
on i
n th
is
m
an
u
al
m
ay b
e c
h
an
g
ed at a
ny ti
m
e a
n
d w
ith
ou
t o
b
lig
ati
on o
n th
e p
art of C
am
e C
an
ce
lli
A
uto
m
ati
ci
S
.p.a. to n
otify s
ai
d c
h
an
g
es.
Dimensions
Description of parts
1- Top cover
2 - Adjustments cover carter
3 - Electric card rack
4 - Endstop tabs
5 - Electronic card
6 - Front cover of the control panel
7 - - Access fl ap for reaching the release
8 - Anchoring plate
9 - Fastening bolts
10 - Plate for fastening bolts
11 - Fastening nut
Installation must be carried by skilled, qualified technicians in accordance with current regulations.
Preliminary checks
Before beginning to install, do the following:
• Make sure the gate is stable, and that the castor-wheels are properly greased and in good working order.
• The floor guide must be well-fastened to the ground, completely on the surface and free of any irregularities that may obstruct the
gate movement.
• The upper guide-sleds must not cause friction.
• Make sure there are opening and closing strike plates.
• Make sure that the point where the gearmotor is fastened is in an impact-free zone, and that the surface is solid;
Set up a suitable omnipolar cut-off device, with distances greater than 3 mm between contacts, wit sectioned power source;
•
Check that any connections inside the container (made for continuity purposes of the protective circuit) be fitted with extra
insulation compared to other internal conductive parts;
• Set up proper conduits and electric cable raceways, making sure these are protected from any mechanical damage.
Installation
