M
PROG
PROG
>3’’
>3’’
1
3
3
A
D
3
B
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
3
C
E
F
beep
beep
3
8
4
6
9
7
5
2
1
100 °
82 °
54 °
72 °
1÷9
0
9
PROG
PROG
7
8
8
<1’’
<1’’
2
P
age
6
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
6
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
6
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
Programming the call keys.
Press the door release
and AUX2 buttons
5
. On
the entry panel, press the call key to be linked to the receiver
6
: a beep will confi rm
that the setting has been stored. Continue, repeating the same operations for all the
other receivers.
Exiting Programming.
Briefl y press the PROG key on the power supply
7
: the PROG
LED and the LEDs on the entry panels will go out. NOTE. If no action is performed, the
procedure will end automatically after 30 minutes.
Programming entry panel video cameras.
While programming the call keys the
"visual range" of the video camera can be adjusted from any receiver (with handset
raised, it there is one), by pressing on the "Self-connection" key
8
. From the default
settings it is possible to scroll through the following ones
I
by pressing the AUX1
key or to go back to the previous ones with the AUX2 key
J
: the setting is saved
automatically.
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, the oper-
ation shown in fi gure
3
is carried out on these as shown in fi gure
3
C
.
Programming Type of Keys.
Press the fi rst key on the entry panel
3
/
3
A
/
3
B
until
the
LED stops fl ashing along with the backlighting LEDs
4
.
PROGRAMMING ENTRY PANELS WITH VA/01
First Programming with ONE entry panel
Entering Programming Mode.
Press the PROG key on the power supply
1
until the
PROG LED lights up. If the PROG LED immediately goes out, this indicates a malfunction
in the connections between the power supply and the entry panel. Check the connec-
tions and return to programming. The LEDS on the entry panels light up as shown in fi g-
ure
2
. Wait 5 seconds for the auto test to be completed and continue as shown below.
