3
3
A
4
3
B
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
3
C
5
6
beep
beep
PROG
M1
CN4
B
B
>3’’
>3’’
<6’’
<6’’
1
+
7
1-2-3
1-2-3
12345
12345
beep
beep
8
+
+
2
P
age
12
- Manual
FA01031-IT
- 08/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
12
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - T
ranslation of the
original instructions
P
age
12
- Manual
FB00865-EN
- 11/2019 - © C
AME S.p.A. - The contents of this manual may be changed, at any time, and without notice. - Original instructio
ns
PROGRAMMING ENTRY PANELS WITH VAS/100.30 or VAS/101
First Programming
Entering Programming Mode.
Press the PROG key
1
for at least 3 seconds and
release within 6 seconds. If the PROG LED immediately goes out it means there is a
malfunction. Check the connections and return to programming. The LEDS on the entry
panels light up as shown in fi gure
2
. Wait 5 seconds for the auto test to be completed
and continue as shown below.
Programming Type of Keys.
Press the fi rst key on the entry panel
3
/
3
A
/
3
B
until
the
LED stops fl ashing along with the backlighting LEDs
4
.
Programming the call keys.
Press the door release
and AUX2 buttons
5
. On
the entry panel, press the call key to be linked to the receiver
6
: a beep will confi rm
that the setting has been stored. Continue, repeating the same operations for all the
other receivers.
Programming the door release code and relay with DNA.
Press and key in the
relay code you wish to programme (press key 1 to activate the door opening control in
the entry panel; press key 2 to activate relay 1 on the VLS/2 relay module; press key 3
to activate relay 2 on the VLS/2 relay module)
7
. Press once again and key in the
desired code (from 3 to 5 fi gures). Once programming has been completed, by pressing
the key plus the desired code and it is possible to activate the door opening control
and relay 1 or 2
8
.
Exiting Programming.
Briefl y press the PROG key
I
: the PROG LEDs and entry panel
LEDs will go out. NOTE. If no action is performed, the procedure will end automatically
after 30 minutes.
Should call keys be present ONLY ON ADDITIONAL BUTTON PANELS, the oper-
ation shown in fi gure
3
is carried out on these as shown in fi gure
3
C
.
