10 - 24803960 15-09-2014
DDI
OFF ON ON ON
Reset
ON ON ON ON
Dip S/W
Feature
S6
D1
Extended ID
D2
Baud rate
D3
D4
S5
D1
Protocol
D2
D3
D4
Baud Rate
S6
D2
D3
D4
2400 bps
OFF
OFF
OFF
4800 bps
OFF
OFF
ON
9600 bps (default)
OFF
ON
OFF
19200 bps
OFF
ON
ON
38400 bps
ON
OFF
OFF
Extended ID
D1
1/99
OFF
1/3999
ON
Video output connection
RS485 connection
The Dome videocamera is fi tted with a RS-485 receiver that can
be remotely controlled, via an external control device, for example
a joystick or a DVR DVR.
RS-485: connect TXA (Tx+) and TXB (Tx-) of the control devices
RS485 (KBD, DVR…) to TRX+, TRX- of the Dome videocamera.
The RS-485 does not support using a star connection layout.
For such a connection type, you a serial distributor.The RS-485
supports a distance of 1.2 km, so for greater distances we suggest
using repeaters.
Connecting the alarms
From AL1 to 8 (ALARM IN)
To receive and answer from the videocamera about an event, you
can use magnetic sensors, PIR or others
GND
Connect the ground to the Alarm input and/or the Alarm output
to the GND connector.
NO/NC (Clean contact relay output)
The video camera may activate external devices, such as buzzers or
lights via a relay switch. Connect the device to the NO connectors
(NC) (Alarm Out) and COM (Common).
Connecting up to the power supply
Connect the 24 VCA 80VA power supply to the Dome videocamera.
Mounting
Description of parts
Hooking slot;
Left hook;
Right hook;
Fastening screw;
20 pin connector.
After setting the switches and making the connections as
explained above, you can mount the videocam. Take the end of
the Dome videocam with you hand, as illustrated in the drawing.
1. Line up the two yellow stickers and slide the left hook along
the guide rail until it snaps into place.
2. Now move the end of the videocam upwards and tilt it until
the right hook snaps into place. The 20 pin connector will insert
automatically
3. Immediately fasten the locking screw to the right hook.
You can install the videocamera onto a supporting structure that
can hold 5 kg of weight.
Dismantling and disposal
Always make sure you comply with local laws before dismantling
and disposing of the product.
The packaging materials (cardboard, plastic, and so on) should
be disposed of as solid urban waste, and simply separated from
other waste for recycling.
Other components may contain pollutants. They must therefore
be removed and handed over to fi rms authorized to collect and
dispose of them.
DO NOT DISPOSE OF IN NATURE!
The data and information in this manual may be changed at any
time and without notice.
