Page
2
0
20 - Manual
FA
01
19
5-
EN
- 0
6
/2
01
8 - © CAME S
.p.
A
.. - The contents of this manual may change, at any time, and without notice. - Translated original in
structions
F 1
Total stop function (1-2)
F 2
Function associated with the 2-CX input
F 3
Function associated with the 2-CY input
F 5
Safety test function
F 6
Hold-to-run function
F 7
Command mode on 2-7
F 8
Command mode on 2-3 / 2-3P
F 9
Obstacle detection with motor at standstill function
F 11
Encoder disabled
F 13
Thrust during closing
F 18
LED lamp
F 19
Automatic closing time
F 21
Pre-flashing time
F 22
Working time
F 25
LED lamp time in courtesy mode
F 28
Speed adjustment during opening
F 29
Speed adjustment during closing
F 30
Slowdown speed adjustment during opening
F 31
Slowdown speed adjustment during closing
F 33
Calibration speed adjustment
F 34
Sensitivity during movement
F 35
Sensitivity during slowdown
F 36
Partial opening adjustment
F 37
Initial slowdown point adjustment during motor opening
F 38
Initial slowdown point adjustment during motor closing
F 40
Initial approach point adjustment during motor closing
F 46
Setting number of motors
F 47
Slowed start during closing
F 50
Saving data in the memory roll
F 51
Reading data from the memory roll
F 60
Sleep Mode function
U 1
Inserting a new user
U 2
Deleting a single user
U 3
Deleting all users
A 2
Motor test
A 3
Run calibration
A 4
Reset parameters
A 5
Number of manoeuvres
H 1
Software version
Important! Start programming, performing these operations first:
1 Motor test;
2 Run calibration.
A2 Motor
test
0 = Disabled / 1 = Enabled
Check the operation of the gearmotor and the correct direction of rotation(see motor test paragraph)
A3 Run
calibration
0 = Disabled / 1 = Enabled
Automatic door run calibration operation (see run calibration paragraph).
A4 Reset
parameters
0 = Disabled / 1 = Enabled
Caution! If necessary, you can restore the default parameters with the following function:
Data reset operation data (default settings) and run calibration deletion.
A5
Number of manoeuvres
1 = 1000 manoeuvres; 100 = 100000 manoeuvres; 1.0 = over one
million manoeuvres
View the number of manoeuvres of the overhead door.
Motor test and calibration menu
Menu mapping
