CAMDEN EXACT CX-DA400, Installation Instructions Manual

Page: 2 / 6

Page 2 of 6
CX-DA400 Door Prop Alarm Installation Instructions
• Silent Time - “Open Door” Time - 0-2.5 min. in standard mode,
3 - 90 min. in Extended mode (selected by Jumper 9).
• Alarm Delay - “Warning” Time - 0-5 min. and “Infinite.” Local
Beeping Warning Audible sounds during this time.
• Auto Reset - “Alarm” Time - 0-5 min. and Manual Reset.
Constant Alarm Audible sounds during this time.
• Shunt Delay - Valid Access Time prior to reset if Door is
unopened. 0, 5, 10, or 20 seconds (set with Jumpers 7 & 8).
TIMERS
SET
ALARM
DELAY
TIME
SELECT
AUTO
RESET
TIME
SELECT
0
0 Sec 3 Min 0 Sec 0 Sec
1
3 Sec 3.5 Min 3 Sec 3 Sec
2 5 Sec 4 Min 5 Sec 5 Sec
3 7 Sec 4.5 Min 7 Sec 7 Sec
4 10 Sec 5 Min 10 Sec 10 Sec
5
12 Sec 6 Min 12 Sec 12 Sec
6
15 Sec 7 Min 15 Sec 15 Sec
7
20 Sec 8 Min 20 Sec 20 Sec
8
25 Sec 9 Min 30 Sec 30 Sec
9
30 Sec 10 Min 45 Sec 45 Sec
A 35 Sec 20 Min 1 Min 1 Min
B
45 Sec 30 Min 2 Min 2 Min
C 1 Min 40 Min 3 Min 3 Min
D
1.5 Min 50 Min 4 Min 4 Min
E 2 Min 60 Min 5 Min 5 Min
F 2.5 Min 90 Min INFINITE MANUAL
TIMER SETTING TABLE
SIDE VIEW
NORMAL
Jumper OFF
EXTENDED
Jumper ON
SILENT TIME
SELECT
(Extended Silent Time Jumper)
TAMPER CIRCUIT
- Alarm is not reset with key.
(CX-DA401 only)
• TAMPER SWITCH - Switch is located on stand-off under spring steel
actuator. (Cut cable tie to Enable switch)
• DOOR SUPERVISION - Enable with Jumper 1. Requires resistors on
Door Switch. (Schematic on Step 1 Pg.3)
OPERATION
VALID ACCESS / PROPPED DOOR OPERATION
ARMED STATE - Red LED (Green if Intrusion Detect is Off)
VALID USER INPUT - Shunt or Voltage Sense Input
LED - Changes to Green
DOOR - Opened by user, Silent Timer begins
DOOR - Closed by user, Returns to Armed State, or
- SILENT TIME TIMER - expires, then
AUDIBLE WARNING - Beeps to alert user locally
LED - Flashes Green
DOOR - Closed by user, returns to Armed State, or*
- SHUNT RECYCLE - 2nd Valid User Input (*if enabled)
SILENT TIME RESET - Silent Timer begins again
DOOR HELD/PROPPED - Alarm Delay Times out
LED - Flashes Red
AUDIBLE - Constant tone, Auto Reset (AR) Timer begins
OUTPUT - Door Prop Alarm relay toggles
DOOR CLOSED - After Door Prop Alarm exists
AUDIBLE - On until Auto Reset (AR) Time expires
LED - Flashes Red for AR Time
OUTPUT - Relay held for duration of AR Time
INTRUSION OPERATION
ARMED STATE - Red LED
DOOR Opened by invalid entry
LED - Flashes Red
AUDIBLE - Constant tone, Auto Reset (AR) Timer begins
OUTPUT - Intrusion/Tamper Alarm relay toggles
- DOOR CLOSED
LED - Flashes for duration of AR Time
AUDIBLE - Continues for duration of AR Time
OUTPUT - Changed for duration of AR Time
- REARM - After AR time expires OR by Manual reset
LED - Red (Armed State)
TAMPER OPERATION
(CX-DA401 only)
ARMED STATE - Red LED (Door Supervision Enabled)
- TAMPER (Door circuit open/shorted, or if unit is
removed from wall)
LED - Flashing Red
AUDIBLE - Constant tone
OUTPUT - Intrusion/Tamper Alarm relay toggles
- RESET - Door normal, and Tamper switch closed
LED - Red (Armed State)