CX-EPD1289L Electric Preload RIM Strike
INSTALLATION INSTRUCTIONS
Page 2 of 7
Introduction
RIM electric strikes, used with Pullman latch devices
(i.e. exit devices) are very different from installing an electric
strike for cylindrical or mortise lock sets, and therefore require
additional considerations and a different installation technique.
Camden CX-EPD1289L is designed to provide up to 15 lbs of
preload on the strike keepers. This unique feature eliminates
typical installation challenges caused by warped or misaligned
doors, frames or locking hardware.
4. INSTALLATION
Step 1: Using the Install Jig
Align template edge
with
the jamb edge
(
Note :
While aligning the
template with the Jamb
edge, If the door keeper
does not align with the
template cavity, Adjust the
template)
Note:
1. Open door slightly. Place template on door jamb
aligning templates edge with jamb edge.
Note:
1. Open door slightly,
and remove the template.
Note:
1.
Close door making sure template is in place.
Align Crash bar latch with template latch hole.
2.
Mark holes center on the frame with a pencil or marker
3. While aligning the template with the Jamb edge, If the
door keeper does not align with the template cavity,
Adjust the template
Note:
1.
Use a hole punch on marked positions.
2.
Use drill size 5/8” to drill hole B
.
3.
Dril
l and tap holes A for 1/4-20x1-1/4" screws.
Marker/
Pencil
Closed
Door
8
Door Jamb
Crash
Bar
Marker/
Pencil
Jamb
Jamb
Hole punch
Hole punch
Ø
5
8
''
Ø
5
8
''
3
8
''
43
16
''
43
16
''
158''
Connecting
wire hole
Connecting
wire hole
Holes for
self-tapping
screws
A
A
B
1
2
5
4
3
