3
II. Assembly Instructions (continued)
Umbrella
With sneeze guard assembly already in place:
1.
Place umbrella into pole.
2.
Let umbrella pole slowly drop into centerpole
until button snaps into location hole.
Sneeze Guard and Canopy
1.
When canopy is ordered with the vending cart unit
(ModelsKVC854C or KVC856C), sneeze guard end
poles as well as poles to the back or operator’s
side, will be 49" long and telescopic.
2.
Place the 36" rigid pole into the center hole on the
customer side of the countertop.
3.
Set the bottom clear panel (11
1
⁄
4
" x 78
3
⁄
4
") into the
groove along the front edge or customer side of
the countertop.
4.
Place the shelf section down over the center pole
until it is firmly resting on the clear panel below it.
5.
Place one of the telescopic poles down through the
shelf and into the countertop hole on the end of
the shelf where it is wider for serving.
6.
Slide the small sneeze guard panel
(14
1
⁄
2
" x 40
5
⁄
8
") on to thecenter pole making sure
the bottom edge of the panel fits into the groove
on the top side.
7.
Place the next telescopic pole down through the
hole or slot of the top sneeze guard, the shelf, and
finally into the hole of the countertop section.
8.
Put the remaining two telescopic poles into the
two holes onthe operator’s side.
9.
Rotate all 4 poles so that the knobs on the black
clamps arefacing outward on both ends of the
cart. Then tighten the setscrews in each black
bushing as well as the thumb screws on the shelf
section being sure to check that the shelf has a
level appearance.
10.
Place the canopy on top of the 4 poles and tighten
the thumbscrews at each corner of the canopy.
Bottom Sneeze Guard
Shelf
36" Pole
Small Sneeze Guard
Thumb Screw
49" Telescopic Pole
Black Bushing with
Set Screw
3-Lobe Knobs
Thumb Screw
