BASIC CONNECTION
The diagram below shows the basic connection of your unit to a CD player and a
turntable and a pair of loudspeakers.
Connections
LOUDSPEAKERS
Check the impedance of your speakers. When using a pair of speakers, you can
use types with an impedance of between 4 and 8 Ohms. When using two pairs of
speakers, you must use types with an impedance of 8 Ohms each, see later section.
The red coloured speaker terminals are positive (+) and the black speaker terminals
are negative (-). Make sure correct polarity is maintained at each speaker connector
or the sound can become weak and “phasey” with little bass.
USING BARE WIRE CONNECTIONS
Prepare the speaker cords for connection by stripping off approximately 10mm (3/8”)
or less of the outer insulation. More than 10mm could cause a short circuit. Twist
the wires tightly together so there are no loose ends. Unscrew the speaker terminal,
insert the speaker cable, tighten the terminal and secure the cable.
Note:
All connections are made using standard loudspeaker cable.
L
R
Digital Output
Digital Output
S/P DIF
Co-axial
AXR
Right
speaker
Left
speaker
CD player
Red
Red Black Black Red
Black
Red
Black
Turntable
Optional Subwoofer
