Cambium PTP 670 Series, User Manual

Page: 399 / 594

Chapter 6: Configuration and alignment System menu
Page 6-40
Figure 149 System Configuration page, TLS RSA Encryption Algorithm
Caution
Configuring link encryption over an operational link will necessitate a service outage.
Therefore, the configuration process should be scheduled during a period of low link
utilization.
Procedure:
•
If AES encryption is required but the System Configuration page does not contain the
Encryption Algorithm attribute, or if the Encryption Algorithm attribute provides only the
None and TLS RSA attributes, then order the necessary AES capability upgrade, generate a
license key and enter it on the Software License Key page (
Software License Key page on
page 6-13 ).
•
Update the attributes ( Table 159 ).
•
To save changes, click Submit Updated System Configuration.
•
If a reboot request is displayed, click Reboot Wireless Unit and OK to confirm.
Table 159 System Configuration attributes
Attribute Meaning
Enable
Transmission Only displayed when the ODU is a Master unit and Transmitter Mute
Control is enabled (see
Webpage Properties page on page 6-78) .
Use the Mute Transmission/Enable Transmission control to toggle
between Muted and Enabled.
Muted: The ODU will not radiate and will not forward Ethernet frames
between the wireless interface and the Ethernet ports.
Enabled: The ODU is allowed by the user to radiate and will forward
Ethernet frames between the wireless interface and the Ethernet ports.
Link Name This is only visible if the Wireless Topology is set to PTP topology.
Link Name may consist of letters (A-Z and a-z), numbers (0-9), spaces, and
the following special characters: (),-.,:<=>[]_{}.
If Access Method is set to Link Name Access, Link Name must be same at
both ends of the link and different to site name.
Unit Name Unit Name may consist of letters (A-Z and a-z), numbers (0-9), spaces, and
the following special characters: (),-.,:<=>[]_{}.
Unit name should be unique within the wireless network.