Chapter 5: Radio Configuration
Configuring Frame Cut-Through
phn-3965_006v002
Page 5-19
Configuring Frame Cut-Through
Using the Frame Cut-Through feature, frames assigned to queues with 4th priority pre-empt frames already in
transmission over the radio from other queues. After the 4th queue frames have been transmitted, transmission of
the pre-empted frames resumes .
Note
The Frame Cut-Through configuration must be identical on both sides of the link.
If Frame Cut-Through is used together with 1588 Transparent Clock, the 1588 packets must be given
a CoS that is not assigned to the fourth priority queue.
To configure Frame Cut-Through:
1.
Select
Radio > Ethernet Interface > Configuration
. The Radio Ethernet Interface Configuration page opens.
Figure 164
Radio Ethernet Interface Configuration Page
2.
In the Radio Ethernet and Compression table, select the radio you want to configure.
3.
Click
Edit
. The Radio Ethernet Interface Configuration
–
Edit page opens.
Summary of Contents for PTP 820 Series
