cam SHP Series, Operating Manual

Page: 26 / 36

26/36
8. TROUBLESHOOTING
N° Problem Cause Action
1 Impossible to
sideshift the load Oil leak Check the connections.
Replace or repair the pump/valve
Replace the seals
Air in the hydraulic system Bleed the air from the system, run the
cylinders through several lift cycles.
See chapter 5.3.1.
Not enough space for the hydraulic
connection to move freely Prevent blockage of the hydraulic system,
connect the hydraulic system as indicated
Incorrect mounting of the hydraulic
connection Check if the hydraulic system is
connected to the correct hydraulic hoses.
See chapter ‘5. Assembly and installation’
Hydraulic pressure is too low or incorrect
flow from the lifting device Make sure you use the correct oil. Read
the instructions in the manual of your
lifting device
Worn bearings Replace the bearings. See spare parts list
attached for the correct reference
Dirt in the hydraulic oil In case of dirt in the hydraulic system, it is
necessary to change the oil completely.
It is forbidden to change the hydraulic oil
yourself.
May only be carried out by a qualified
service technician and according to the
manufacturer’s instructions.
2 Impossible to lift or
lower the load Malfunctioning of the hydraulic
connections See chapter ‘7.3. Maintenance
instructions’.
Consult the manual of your lifting device
Leaking cylinder Repair or replace the cylinder.
May only be done by a qualified service
technician and according to the
manufacturer’s instructions.
See spare parts list attached for the
correct reference
If none of these troubleshooting suggestions or solutions were helpful, please contact your local
dealer or the manufacturer.