Calrec ARGO, Installation & Technical Manual

Page: 24 / 92

24 ARGO
Digital Broadcast IP Production Console
Control Surfaces
The UN6539 uses a combination of
USB 3.0 ports for the Surface Control
Panels, Display Ports for the TFT
Displays, USB 2.0 ports for Touch
control on the TFT's and User USB
ports such as the one on the MY6549
Monitor Panel, which also has a RJ45
Studio Hub socket on it to connect the
Talkback Microphone to the JB6549
Combo I/O unit.
There are 3 x USB 3.0 Type A (blue)
connectors which connect to the Surface
Controller PCB's fitted in each of the
Control Surface Panels via USB 3.0
Type B connectors, 2 x DP Display Port
1.4 (yellow) interfaces which connect to
the Meter TFT and the Touch Display
TFT which also has a USB 2.0 Type B
connector connected to it on the rear
from the "Touch" USB 2.0 type A (white)
connector on the Section Processor.
The Monitor panel provides a user USB
2.0 connection for memory sticks or
keyboard/mouse combinations which
can be connected to one of the USB 2.0
type A (white) ports numbered 1 & 2 on
the left side of the section processor.
These 6 connectors are highlighted on
the image in Fig 1 above right.
Fig 2 below right shows the Control and
Display connections for the panels and
displays, a 2 section part of an Argo Q
Console which contains an extra row
of panels. From bottom to top the
panels and displays are controlled from
the connectors, left to right across the
UN6539 section processor.
Panel 1's USB 3.0 port provides controls
and displays on the IU6576 Standard
Fader panel.
Panel 2's USB 3.0 port provides controls
and displays for either the CA6575 Wild
Assign panel, IU6577 Short Fader panel
or the MY6574 Monitor panel.
Panel 3's USB 3.0 port is only used for
Argo Q with the extra row of panels.
Note: an Argo S does not use this
connection.
SURFACE CONTROL & DISPLAY CONNECTIONS
FIG 2 - USB3, DP & USB2 PANEL CONNECTIONS FOR TWO SECTIONS
FIG 1 - DATA CONNECTIONS ON UN6539 SECTION PROCESSOR
Display 1's DP connector is used for
the MU6572 Touch display TFT panel,
together with it's USB 2.0 touch port
Display 2's DP connector is used for the
MD6573 Meter TFT panel.
The MY6574 Monitor panel has a User
USB 2.0 type B port connected to USB 1
or 2 on the section processor and also a
Studio Hub RJ45 (red) connector for the
Talkback Microphone which is connected
to the rear of the JB6549 Combo I/O unit.