5
D.
TEMPERATURE CONTROL
1.
BUILT-IN Thermostat - Heaters with a factory installed
thermostat are prewired and require only power
connection. The thermostat sensing bulb must be
assembled into its final position. See B.4.7. for final
assembly.
2.
The thermostat supplied is a high quality device with a
factory calibrated range of 50 to 104°F (10 to 40°C). Due
to the proximity of the sensing bulb to the heater, the
actual thermostat setting will not be the same as the
desired room ambient temperature. This is normal with all
unit mounted thermostats. It should be a simple matter to
find the setpoint to provide the desired comfort level.
3.
REMOTE LINE VOLTAGE THERMOSTAT - A remote
thermostat rated to operate on full voltage may be
desired. Installation and wiring of the selected thermostat
must comply with the manufacturer’s instructions.
CCI Thermal Technologies Inc. can supply appropriate
thermostats.
E.
MAINTENANCE
WARNING
WARNING.
The BX convection heater is constructed to
operate in tough industrial applications with minimum
maintenance. However, some routine maintenance is
recommended to extend the life of the heater and its
components. ALWAYS DISCONNECT THE
ELECTRICAL SOURCE BEFORE PERFORMING ANY
MAINTENANCE.
1.
TERMINAL ENCLOSURE - The periodic intervals, but
not more than once a year, open the terminal enclosure
to inspect for cleanliness and dampness. Vacuum any
dust and wipe up any moisture. Check all electrical
connections and tighten if necessary.
2.
HEATER PAINT FINISH - The BX convection heater
is finished with a heavy duty enamel paint to provide
maximum resistance to corrosion due to air-born
contaminants. We recommend the cabinet to be wiped
down periodically using a mild detergent.
Summary of Contents for BX2011S
Page 7: ...NOTES ...
