Plug the modular cable into the RJ11 jack. Note the length of the cable. The LANCNC
controller board will need to be within the distance of the cable length when mounted.
Locate a good position for the USBCNC controller board. It will need to be within the distance
of the display cable, serial cable and the power plug. Secure the din rail as shown below.
Attach the din rail clips to the LANCNC controller and mount to the din rail. Check for spacing.
The two outer holes from the din rail clips can be used to release from the clips with a small
screwdriver.
Plug the modular cable from the display into the RJ11 connector
J3
on the LANCNC controller
board.
J3
