A L K A L I N E I O N I C W A T E R S Y S T E M
1. ATTACH DIVERTER TO YOUR TAP – Remove the aerator from tap (pliers may be required), and attach
diverter valve in its place. There are adapters supplied in case the diverter does not fit your tap.
If you have leaks at the diverter, use plumber’s Teflon tape (available at any hardware store for a couple of dollars).
2. CUT A FOUR INCH LENGTH OF WHITE HOSE - Using a very sharp utility knife, cleanly cut a four inch
length of the white hose. The cleaner you make your cut, the less likely you will experience a leak.
3. ATTACH THE IN-LINE PRE-FILTER –
There is a small black arrow on the pre-filter indicating water flow direction.
The arrow on the pre-filter will POINT AT YOU IONIZER indicating water
flowing toward the ionizer. Insert the four inch length you cut into the end
of the pre-filter making by pushing firmly ensuring the arrow is pointing
at the end of the four inch hose. The four inch length will be between
your ionizer and the pre-filter.
4. ATTACH THE TAP WATER INLET HOSE TO YOUR IONIZER –
Attach the free end of the four inch length of white hose with the pre-filter
attached to the gray port on the bottom of the ionizer. To attach the white inlet
hose, by pushing it firmly into the grey tap water inlet port.
(To remove it, press on the end of the fitting and pull it out at the same time).
5. POSITION YOUR IONIZER – This can be beside the sink, to the rear of the sink, or on the wall above the
sink (there are keyhole slots on the back for this). Make sure it is on a hard and level surface
Connect the external valve between the hoses.
If the water pressure is excessively high, adjust the water flow by turning
the external valve.
To get the proper pH and ORP value of ionized water, set the external valve
to allow 1.5 liters of water per minute to flow through the ionizer.
How to install the external valve
Installation method
How to Install
To have the pe of ionized water, adjust the volume of water flow to
the level 2 controlling the external valve.
How To Install
Accessories
Inlet
Acidic water
outlet
pH test kit
Spare adaptor
Hose
Color chart
Manual
1/4” hose
DUST PRE- FILTER
Your new Orion gives you the option of three installation methods:
1) at your sink attached to your faucet with a diverter,
2) at your sink but plumbed directly to your cold water line (no diverter) and,
3) undersink - completely out of sight with a small dedicated faucet.
It is recommended that methods 2) & 3) be done by a plumber.
Installation Method 1.
At the sink with a diverter (easiest)
