Installation of the rear extension
There are two ways to attach the telescopic rails to the floor rails:
Installation variant A:
•
Attach telescopic rails to the rear system profile (
2
) with countersunk screw (
8
) M5x12
and square nut. The angles are flush with the profile.
•
Insert the drawer into the telescopic rails. (The ball cages should be pushed all the way
back (towards the drawer).
•
Lift the rear extension on the right so that the left holders go under the cabinet profile.
•
Lower, and attach to the ground screws.
•
Place washer and tighten with M6 nut.
Note:
The ground screws can be moved to the left and right if the holes are not exactly above the
ground screws.
.(Film)
The film shows the older version with column profile(x
2
) and center profile (x
1
).
Installation variant B:
Install the left and right telescopic rails individually. If the ground screws do not fit exactly
through the holes, the ground screws can be moved to the right or left. Then screw the rear
floor profile to the angles.
Then insert the drawer as described above.
