![background image](http://html1.mh-extra.com/html/calimet/ra-i00h/ra-i00h_instruction-manual_3441791002.webp)
Figure 1
,
Tighten screws after receiver is plugged in
Once the power is on, signal light starts blinking when properly installed.
3
.
Program Numerical or Learning Mode
Numerical Mode:
1. Unscrew the bolts on the remote
2. Key 1 & Key 2 are compatible with two button remote.
Choose
only one button for setting ( not suitable for Learning
Mode)
3. Coding: According to the combination code, use precision screwdriver or
similar object to push each code accordingly. (note: numerical code are set
by receiver and remote, they range from 1-8, choose up-middle-down three
positions to set the combination.)
4. Choose DECODE on the remote. Make sure the code that set for the
remote matches with the one in receiver.
5. Screw the bolts to close remote and receiver after codes are matched, plug
receiver back.
Learning Mode:
1
.
Initial setting up: Press and hold learning mode button for 10 seconds, LED
changes from blinking to solid then back to blinking, release the button. The
initial setting is to clear any factory preset. No initial setting is necessary for
subsequent remote.
2
.
Press and hold learning button on receiver for 2-3 seconds, release after
light turns solid. Press and hold remote button until light blinks.
3
.
For dual button remote, choose any button for set up.
4
.
Receiver can set up for a maximum of 80 remotes. (Note: The very first
remote will be canceled if 81
st
remote is set)