![background image](http://html.mh-extra.com/html/calimet/cm9-864/cm9-864_instruction-manual_484594002.webp)
Figure 1
,
Tighten screws after receiver is plugged in
Once the power is on, signal light starts blinking when properly installed.
3
.
Program Numerical or Learning Mode
Numerical Mode:
1. Unscrew the bolts on the remote
2. Key 1 & Key 2 are compatible with two button remote.
Choose
only one button for setting ( not suitable for Learning
Mode)
3. Coding: According to the combination code, use precision screwdriver or
similar object to push each code accordingly. (note: numerical code are set
by receiver and remote, they range from 1-8, choose up-middle-down three
positions to set the combination.)
4. Choose DECODE on the remote. Make sure the code that set for the
remote matches with the one in receiver.
5. Screw the bolts to close remote and receiver after codes are matched, plug
receiver back.
Learning Mode:
1
.
Initial setting up: Press and hold learning mode button for 10 seconds, LED