Be sure to install CMARCIC after the filter and heater. The CMARCIC cell shall be at least three (3) feet from
the outlet of the heater.
If CMARCIC is installed on a combined swimming pool/spa system, please install it before the backflow valve
of the swimming pool/spa (see the figure below). This way both the swimming pool and spa can be properly
chlorinated, and gas accumulation in the swimming pool water pipes can be avoided.
Install CMARCIC cell horizontally.
Determine the size of the pool (gallons of water in the pool)
Determine the size of the pool (liter of water in the pool)
Caution: To protect the service life of CMARCIC, do not use dry acid (sodium bisulfate) to adjust the
pH value in arid geographical areas. This will cause excessive evaporation and minimize the dilution of
pool water with fresh water.
ATTENTION:
Make sure you have disconnected the power supply before installing!
Grounding (earthing) is required. This unit should be installed and grounded by qualified service personnel. Installed
to allow access to unit buttons and power centers.
Please read the safety precautions and important instructions on page 1. Be sure to read and observe the safety
instructions before making any electrical wiring. Wiring can only be done by qualified professionals.
The CMARCIC cell shall be installed at least three (3) feet from the outlet of the heater.
Pipe coupling: Schedule 80, with a maximum pressure of 75 psi at 70°F (21°C).
How to install cell:
1. Install the PVC coupling to the plumbing pipe with PVC glue. Let the glue dry.
2. Install the cell vertically. Allow access to the unit operator control panel. Install the cell on the coupling.
Make sure that the O-ring is properly seated.
3. Turn on the pump and visually check whether there is leakage around the coupling.
Connecting the Cell Cable to the Power Center
Warning-Please turn off the power of the main system before making any connection.
Rectangular Pools
Length x width x average depth x 7.5
Round Pools
Diameter x diameter x average depth x 5.9
Oval Pools
Length x width x average depth x 6.7
Bevel
Multiply total gallons by 0.85 = gallon capacity
Rectangular Pools
Length x width (meters) x average depth x 1000
Round Pools
Diameter x diameter x average depth x 785
Oval Pools
Length x width (meters) x average depth x 893
Bevel
Multiply total liters by 0.85 = liter capacity