7
Pool Assembly / Liner Layout
Step 1:
Locate the area most suited for setting up the pool. Clear it of any sharp objects or debris and level it to zero as ex-
plained on the “Preparing the Ground” page. If the pool is assembled on unleveled ground, it may suffer permanent
structural warping or damage the liner.
Step 2:
Remove the liner from the box marked “Liner” and place it at the center of the area where you plan to assemble the
pool. Take care not to damage the liner when opening the box. DO NOT USE SHARP OBJECTS TO OPEN THE
BOX THAT CONTAINS THE LINER.
Step 3:
Unfold the liner. Locate the place where the pump and filter system will be connected and position the 2 circular open-
ings on the side where you intend on placing the pump and filter.
Step 4:
Remove the frame (Parts A & B) from the box marked “Frame”. At this point you will not need any “U-Tubes” (Part
C). Lay all of the upper frame out in the order indicated below. (Locate each frame piece corresponding with the parts
list on page 5.)
'
'
