STEP 3:
Screw in (3) 2.5” Hex Lag Screw, Stack of 3 Washers per hole and Lock Washers as displayed
below. Make sure left handles go on left shields and right on right. Align the fasteners straight into
the holes of the shield and into the pilot holes of handles. Align and fasten bottom fastener first.
Do
not over tighten.
If you over tighten, the screw may protrude on the front side of the handle. Be
careful to watch the front of the handle to make sure you don’t go too far.
Left Shield
First Fastener
STEP 4:
Align the LowPro Grip Glide with left Shield and screw in (28) 1” Truss Head Screws starting in the
center first, then the outside as show below (Some may be partially installed) Do
not over tighten.
Insert these 2
fasteners first
STEP 5:
Drill first 2 holes on left side of the trailer for 1
st
bracket closest to nose of the trailer. Holes should
be 3/8” diameter and drilled 1 -1/2” down from top of trailer top edge and 8” from nose of trailer.
Use provided bracket to drill second hole 1-1/2” below first hole. Insert 5/16” bolts along with
large fender washers on face of bracket followed by washer and lock nut in back. Fasten tight with
a 1/2” wrench.
Some models require hinge bolts with threads the full length (not included).
Trailer Top Edge
CALIBER
®
952-985-9999
CI5009
2
