2
Contents of the package
Repeaters
cod. 720081 (100..240Vac 50-60Hz power supply)
N° 1 repeater (100..240Vac 50-60Hz power supply)
N
° 2 5x25 plugs
N° 2 5x30 screws
N°
2
cable glands
Components
Ref. Description
A
Cable compartment lid
B
LED
Ref. Description
1 100..240Vac power supply input (screw clamps)
2 Scan-mode button
3 Unused button
4 Reset button
5
USB port
6
MESH network TX-RX-LED
7
Wireless MBUS network TX-RX-LED
8
Signal/reception level LED
9 State LED
Installation
Important !
Before making any connection, remove the power
supply, connect the wiring, close the lid of the device and then power
the repeater!
Wall mounting and wiring
Ref. Description
1 Hole for upper fixing screw
2
Pre-hole for lower fixing screw
3 Pre-hole for cable passage
4
Electric power supply connection
Connections
USB CONNECTION
CONNECTION AT DATA EASY +
The repeaters are provided with a MESH ID and radio channel.
Make sure that all the repeaters and/or Data Easy
+
have the
same MESH network ID and radio channel through Data Easy
Toolkit software.
Before connecting anything, switch the power off, complete the
wiring, close the lid and power the device on.
Positioning and operating distances
1)
Fix the repeater on
fastening wall at minimum
distance of 20 cm from the
ceiling and from the
adjacent wall.
2)
The maximum operating
distance between Wireless
M-Bus and devices
installed on the same floor
is approximately 25 meters,
evaluated in the absence of
important obstacles such as: walls, columns or reinforced
concrete beams, metal or other metal structures.
3)
The maximum operating distance between Wireless M-Bus
and devices installed on different floors is approximately 15
meters.
