Caledonian Audio
6BM8-ECL82-SE-Classique Assembly Manual
25
25
Power/Main Transformer
As a guide:
1.
Remove all the nuts/washers from the four screws. Please note that the
top cover of the transformer is also held by these four screws
2.
Remove the four screws from the transformer and place the transformer
carefully into the cut-out slot. Please make sure that the orientation is
correct – the primary winding terminals (the 120/240 V) is closer to the
outer edge of the board (don’t worry if you get it wrong – as long as you
use and connect the correct terminals later)
3.
Align the transformer so that all four holes are aligned with the four
mounting holes on the mounting plate
4.
One by one, insert the ceramic washer, washer, shake-proof washer onto
the screw and then finish it off with the supplied nut.
Please note the ceramic (red) washer in between the metal mounting plate
and washer. See Figure 18.
Figure 18 Mounting the main transformer
Summary of Contents for 6BM8/ECL82 SE
Page 1: ...Assembly Manual 6BM8 ECL82 SE 2 5W Classique MKII Version 3 0 Caledonian Audio ...
Page 6: ...6 ...
Page 10: ...10 Figure 2 Filament supply board with the four diodes ...
Page 16: ...16 Figure 8 Main power supply PCB fully populated ...