Ensure tight and secure connections.
8.
Fasten the fuse holder and leads.
9.
Carefully route the “A” wire to where the connection will be made for switch sensing.
•
Connect to “Ignition” if you wish to have GeminiG3 unit turning ON and OFF dependent on the vehi-
cle’s ignition key.
•
Connect to “Accessory” if you wish GeminiG3 unit to be available when the engine is not running, but
still dependent on the ignition key.
•
Connect to a user-supplied control switch.
•
In installations equipped with a “ChargeGuard”, connect to the controlled-side of the ChargeGuard
(remembering that the DC Power lead must NOT be switched).
10.
Make appropriate connections.
Cautions:
Where scraping to bare metal was required, and at the battery posts where wire ends and lugs may
be exposed, apply anti-corrosion compound.
Insert the fuse only when installation is complete and ready to test
.
11.
At the GeminiG3 radiomodem’s position, neatly coil cable slack and attach securely.
2.5
ANTENNA
The main transmitter antenna must be vehicle-mounted to provide a separation distance of 50 cm or more
from all persons and the
antenna gain
must not exceed 5dBi (with a 1.6dB cable loss).
2.5.1
RECOMMENDED TOOLS AND SUPPLIES
•
Circle cutter, hole saw or socket punch for antenna
•
Appropriate crimping tool for type of connection present on the radiomodem unit
15