Cal Spas PATIO, Owner'S Manual

Page: 14 / 80

2020 Portable Spas - LAF
LTR20201163, Rev. E
Operating Y
our
Spa
www.calspas.com
12
Standard, Economy and Sleep Heating
Modes
Your new hot tub is equipped with a heating feature that
gives you complete control of the heating system. When the
hot tub is powered up, it will automatically start in standard
heating mode.
• St will light briefly on the main display. In this mode,
the heating system will automatically maintain the
set temperature. In the economy-heating mode, the
heating system will only activate during filtration times.
• Ec will display solid if temperature is not current and
will alternate with water temperature if measured
temperature is current.
• E conomy mode will heat the water to the set
temperature while Sleep mode, indicated by a SL on
the main display, will also only activate the heater
during the filtering cycles but will only heat the water
to within 20°F (10°C) of the set temperature. Like
Economy mode, SL will display solid when temperature
is not current and will alternate with actual temperature
when it is current.
NOTE: Displayed temperature will only be current after the
pump has been running for at least two minutes.
Switching Modes
• Press the Temp button followed by the Light button.
• Press the same sequence to switch to the next mode.
Activating the Jets
Press the Jets 1 button:
• Once to activate low speed pump.
• Twice to activate high speed.
• Three times to return to turn pump off.
Jets 2
Press the
Jets 2
button to turn pump 2 on. Press it once
again to turn the pump 2 off.
Light
Press the
Light
button to turn on the light. Press it once
again to turn the light off.
Automatic Time-outs
These features will automatically turn themselves off during
periods of continuous use:
•
Low speed pump After 4 hours
• High speed pumps After 15 minutes
• Hot tub light After 15 minutes
Setting Filtration Cycles
Your hot tub is programmed to filter twice a day. The first
cycle will begin six minutes after the hot tub is turned on
and the second cycle 12 hours later.
The factory has programmed the cycle to last for one hour
for single pump systems and two hours for two pump
systems, but this can be changed to your preference.
To change the filtration cycle, press the Temp button then
the Jets button. Press Temp button again to change the
filtering cycle duration. See the table below for filtration
settings and duration.
When desired duration is selected press the
Jets
button to
exit.
Single pump systems Two pump systems
Setting Duration Setting Duration
F1 1 hour F2 2 hours
F2 2 hours F4 4 hours
F3 3 hours F6 6 hours
F4 4 hours F8 8 hours
F5 5 hours FC Continuous
F6 6 hours
F7 7 hours
F8 8 hours
Note: Single pump systems do not have continuous filtration.
To set the time of day you want filtration to begin, turn off
the power to the hot tub at the time of day you would like
one of the filtration cycles to begin, then turn it back on
after 30 seconds. When power has been restored, set the
filtration cycle as described above.
During filtration, the water temperature will appear on the
main display.