Cal Spas PATIO, Owner'S Manual

Page: 13 / 80

2020 Portable Spas - LAF
LTR20201163, Rev. E
Operating Y
our
Spa
www.calspas.com
11
Spa Topside Control (Balboa)
Operating Your Spa
For One-pump Systems
When first powered up, your hot tub will perform a self-
diagnostic check and go into priming mode. When the
control panel displays PR , IMMEDIATELY do the following:
1. Press the JETS 1 button to turn on the pump and let
it run for 10 seconds. The pump should be running
in low speed.
2. Press the JETS 1 button again and let the pump run
in high speed for 10 seconds.
3. Press the JETS 1 button again to turn off the pump.
The pump should be left in the off position for 10 to
15 seconds.
4. Repeat steps 1 through 3 until water is flowing
through all the jets and all air is removed from the
plumbing.
When the hot tub has finished priming, the heater will be
activated and the water temperature will be maintained in
standard mode. The hot tub will heat to 100°F (37.5°C) at
start up until the set temperature is changed as described
below.
Initial Start-up
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water
temperature in degrees Fahrenheit. The displayed
temperature will only be current after the pump has been
running for at least two minutes.
To display the temperature that the hot tub is set to:
• Press the
Temp button. The temperature setting will
flash.
• While the display is flashing, each time you press
Temp button, the set temperature will change up or
down one degree.
• If the desired temperature is opposite of the direction
each press of the button is making, release button,
allow display to stop flashing and then press Temp
button to change temperature the other direction.