2010 Portable Spa
LTR20101000, Rev. C
Operating
Your Spa
www.calspas.com
12
Operating Your Spa
5100, 6200 and 6300 Electronic Control Operation
These instructions will describe features and options that your particular spa may not be equipped with.
6200 and 6300 Control Panel
Initial Start up
When first powered up, your spa will perform a self-
diagnostic check and go into priming mode. The
topside will display
PR
to indicate this. Priming mode
will be active for less than five minutes.
Sometimes the pump fails to prime, especially when
spa owners do not fill their spas through the filter
canister. You can avoid priming problems by following
these steps during priming mode.
Press the JETS button to turn on the pump and
1.
let it run for 10 seconds. The pump should be
running in low speed.
Press the JETS buttons again and let the pump
2.
run in high speed for 10 seconds.
Press the JETS button again to turn off the pump.
3.
The pump should be left in the off position for 10
to 15 seconds.
Repeat steps 1 through 3 until water is flowing
4.
through all the jets and all air is removed from the
plumbing.
When the spa has finished priming, the heater will be
activated and the water temperature will be maintained
in standard mode. The spa will heat to 100°F (37.5°C)
at start up until the set temperature is changed as
described below.
Temperature Adjustment
(Range 80°F to 104°F, 26°C to 40°C)
The electronic control panel displays the actual water
temperature in degrees Fahrenheit. The displayed
temperature will only be current after the pump has
been running for at least two minutes.
To display the temperature that the spa is set to:
Press the
•
Temp button. The temperature setting
will flash.
While the display is flashing, each time you press
•
Temp button, the set temperature will change up
or down one degree.
If the desired temperature is opposite of the
•
direction each press of the button is making,
release button, allow display to stop flashing and
then press Temp button to change temperature
the other direction.
5100 Control Panel (one and two pump systems)
