Cal Spas F 1239, Owner'S Manual

Page: 29 / 313

2012 Portable Spa
LTR20121001, Rev. A
W
ater Quality Maintenance
www.calspas.com
26
Traditional Chemical Start Up
Prior to filling a spa for the first time, or after a
routine draining, you will want to follow this start-up
plan to extend water life and performance. If you are
following either the Bromine or Chlorine “Clear Water
Plans”, you will notice that both start-up processes
are the same with the exception of Step 6. As with all
chemical dosages listed in these “Clear Water Plans”,
start-up dosages are intended for 500-gallon spas.
Please adjust the chemical dosages to the capacity of
your particular spa.
Start Up
Clean surface of spa with “Multi-Purpose 1.
Cleaner”.
Apply a protective coat of “Fast Sheen” to the
2.
acrylic surface.
Fill spa to proper water level with normal tap
3.
water (Do not use soft water)
Use test strip and balance the spa water:
4.
Adjust total alkalinity (acceptable range is •
80-120ppm),
Then adjust pH if necessary (between 7.2 to •
7.8).
Pour in 16 oz of “Metal Protector” to center of 5.
spa.
Add either Bromine or Chlorine (According to
6.
your preferred plan)
Bromine: Add 2 oz of “Go Brom” to
establish a bromine base.
Add 2 “Bromine Tablets” to
Bromine Floater.
Set floater opening at #2.
Chlorine: Add two tablespoons of
“Chlorine Granules” to the
spa water.
Sprinkle 2 oz of “Oxidizer Shock” in the center of 7.
the spa and turn on jets for 15 minutes. Leave
spa uncovered during this time.
Put cover on spa and allow to heat up to desired
8.
temperature.
Bromine Clear Water Plan
Day One (Monday)
Test spa water using “Bromine Test Strips”. 1.
Based on the Test Strip readings: 2.
Adjust total alkalinity first (acceptable range •
of 80-120 ppm)
Then adjust the pH if needed (range is
•
between 7.2 to 7.8).
Add bromine tablets if needed. (Do not add
•
more than 2)
The recommended level of bromine is 3-5
•
ppm.
Add 2 oz of “Stain and Scale Defense”. 3.
Remove dirty filter from the spa and rinse off. 4.
Allow to dry.
Place your extra clean filter cartridge back into 5.
the spa.
Vacuum debris from the bottom of your spa with 6.
the “Spa Vacuum”.
Day Two (Wednesday)
Test spa water using Bromine Test Strips. 1.
Based on the Test Strip reading: Adjust total 2.
alkalinity, then the pH if needed.
Day Three (Friday)
Test spa water using Bromine Test Strips. 1.
Based on the Test Strip reading: 2.
Adjust total alkalinity, then the pH if needed. •
Add one Bromine Tablet (if needed). •
Add 2 oz of Oxidizer Shock to spa. Run Spa for 15 3.
minutes with cover off.
Replace cover.
4.