Installation Instructions for Electronic Stand-Alone Cylindrical Locks
- 10 -
PROCEDURES
1. Install latch in door. Be sure that bevel edge of bolt faces strike. Attach with two
screws supplied.
2. Install strike on the door frame.
3. Insert outside assembly through door, making sure that the lock body frame hooks
latch case and retractor engages bolt tail(s). DO NOT FORCE (See Detail A above). If
lock body does not engage latch easily, check door preparation for errors.
3a. Guide motor cable (red and black wires) through 2-1/8"(54mm) diameter hole.
3b. Guide touchpad cable through 1"(25mm) diameter upper hole.
4. Guide motor cable and touchpad cable through rectangular holes on mounting plate
assembly (motor cable - below rectangular hole / touchpad cable - above rectangular
hole).
5. Slide mounting plate assembly over outside assembly, lining up top and bottom screw
guides with holes in door. Secure both assemblies with (5) 10-32x2-9/16" (35mm)
mounting plate assembly screws. Do not over-tighten.
6. Attach motor cable connector to the inside escutcheon PC board lower header.
7. Attach the touchpad cable connector to the inside escutcheon PC board header as
illustrated.
8. Slide inside escutcheon over mounting plate assembly.
CAUTION :
8a. Position motor cable against mounting plate assembly. Avoid pinching wires against
spindle and any sharp metal part of the assembly.
8b. “Z” fold touchpad wire cable and lay against the back recessed area of the inside
escutcheon. Position and bend wires to prevent binding when installing the inside
escutcheon over the mounting plate assembly.
9. Install and secure inside escutcheon with the (2) M5xP0.8-3/4"(19mm) screws through
inside escutcheon and into the mounting plate assembly.
10. Slide inside lever onto spindle and push in to attach.
11. Install (4) AA alkaline batteries into controller compartment being careful to align +/-
polarity properly.
12. Install battery cover and tighten screw.
