7
Mounting Bolt Pattern
Mounting Accessories (optional)
•
Mounting Plate - Stainless steel plate (100 x 260 mm) allows mixer to be securely mounted to an existing horizontal
surface.
• Clamp Set - Stainless steel adapter and c-clamp allows the mixer to be securely mounted to the side of a vessel,
drum or vertical surface. Use the C-Clamp Set to achieve any desired mixing angle.
Chuck and Chuck Shaft Guard Installation
1. Align the chuck set screw hole with the alignment mark on the collar.
2. Slide the chuck onto the motor output shaft until holes are aligned.
3. Tighten the set screw using the tool end of the chuck key (provided) or 3 mm hex key. The mounting screws will be
flush when properly installed.
4. Open chuck and insert the impeller shaft into the chuck to the desired length and secure with chuck key.
5. If desired, install the chuck/shaft guard with provided set screws using the chuck key tool or 3 mm hex Key.
87.56 mm
(3.45 in)
44.52 mm
(1.75 in)
71.75 mm
(2.82 in)
87.56 mm
(3.45 in)
9.09 mm
(0.36 in)
121.10 mm
(4.77 in)
44.92 mm
(1.77 in)
343.48 mm
(13.52 in)
