19
English
•
Raise and close the lever (Fig.1 - 3) to drop a capsule (if present inside) into the special
drawer.
•
Press one of the buttons
A
-
B
-
C
. Wait for the machine to complete the water circuit filling
cycle.
•
When the buttons
A
-
B
-
C
light up steady, the machine is ready to use.
IF THE LEVER IS RAISED DURING DISPENSING:
•
Raising the lever while dispensing a product (Fig.1) can cause splashes of hot water.
Danger of scalding!
•
The indicator light
D
blinks
RED
and the machine beeps intermittently. Dispensing is
immediately stopped.
•
Close the lever (Fig.3).
•
Press one of the buttons
A
-
B
-
C
to reset the alarm.
•
The machine is ready to use again.
Adjusting the cup/espresso cup height
•
The machine can be adjusted for the use of large cups or espresso cups.
•
The machine is initially set for the use of large cups (Fig.7).
•
For best results when using espresso cups, raise the drip-tray and grille, hooking it in the
two top holes (Fig.10).
•
An espresso cup can now be placed under the coffee dispenser (Fig.8).
Dispensing a product
Only use “original Caffitaly System capsules”
•
Raise the lever to open the capsule compartment (Fig.1).
•
Insert the capsule, pressing it gently inside (Fig.2).
•
Close the lever fully (Fig.3).
•
Place a cup or espresso cup under the coffee dispenser (Fig.7 or 8).
• Briefly
press
the button
A
or
B
, depending on the desired coffee.
•
The pressed button blinks. The machine stops dispensing when the programmed amount
is reached, and a beep sounds.
•
Raise the lever to eject the used capsule into the special drawer (Fig.1).
•
Close the lever (Fig.3).
NB
: The amounts of coffee dispensed can be programmed according to personal
taste and the size of the cups or espresso cups used. To program the amounts, see
the section “Programming the amount of coffee in a cup”.
Programming the amount of coffee in a cup
•
Raise the lever to open the capsule compartment (Fig.1).
•
Insert the capsule, pressing it gently inside (Fig.2).
•
Close the lever fully (Fig.3).
•
Place a cup or espresso cup under the dispenser (Fig.7 or 8).
•
To program the button there are two ways:
A) Press and hold the button
for a few seconds, until the machine beeps twice.
On reaching the desired amount of coffee,
press the same button again
.
B) Press and hold the button
. On reaching the desired amount of coffee,
release the
button
.
•
The button is now programmed.
The amount of coffee dispensed can be programmed
from a minimum of 20 to a maximum of 250 ml.
•
Raise the lever to eject the used capsule into the special drawer (Fig.1).
•
Close the lever (Fig.3).
Summary of Contents for S33R.2
