11
General Operating Indications
Heating
• Buttons blink simultaneously.
When the Water Runs Out During Operation
• The water tank is empty when warning light
E
blinks
RED
and the appliance emits 3 beeps
followed by a single intermittent beep.
• Fill the water tank with fresh, still water (Fig. 4).
• Press one of the buttons . Wait for the machine to complete the priming cycle
and fill with water.
• When buttons turn on and remain steadily lit, the appliance is ready for use.
If the Lever is Raised While Dispensing
• Raising the lever while dispensing a product (Fig. 1) may cause splashes of hot water.
Danger of Scalding.
• Warning light
D
blinks
RED
. The appliance will immediately stop dispensing.
• Close the lever (Fig. 3).
• Press one of the buttons to reset the alarm.
• The appliance is ready for use again.
Descaling Signal
• When warning light
D
blinks
YELLOW
and the machine beeps 3 times, a descaling cycle
should be carried out (see chapter 5. Descaling).
Saving Energy
The machine will automatically reduce consumption after 10 minutes of inactivity.
Buttons blink slowly and sequentially. To restore normal operating
conditions, press any button or raise the lever. The appliance will start heating.
When the buttons light up steady, the machine is ready to use.
Adjusting the Cup Tray Height
•
The machine can be adjusted for the use of large cups or espresso cups.
•
The machine is initially set for the use of large cups (Fig. 7).
•
To achieve the best results when using espresso cups, you must lift and turn the grid on
top of the drip tray (Fig. 10).
English
