22
31-2000647 Rev.2
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
C3
•
Read the instructions on the TOP CABINET
TEMPLATE.
•
Tape it underneath the top cabinet.
•
Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
Installation Instructions
You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
Back of Microwave
Fan Blades
Wires
ADAPTING BLOWER FOR
OUTSIDE BACK EXHAUST
Remove the screw holding the blower cover and
remove the blower cover from the back plate of
microwave by sliding it up.
Remove the screws securing the blower plate
and then remove the blower plate from the
outer case by sliding it toward the back of the
microwave and pulling up.
C4
1
2
4
The fan needs to be turned 180 degrees to the
right to be in the correct orientation, keeping
the blower part of the fan where the air comes
out at the top of the fan. The wire needs to
be reinserted into the cae housing once it has
been oriented correctly.
3
Carefully pull out the blower unit. The wires will
extend far enough to allow you to adjust the
blower unit.
Blower Cover
Blower Cover
Screw
Blower Plate
Blower Plate Screws
