CAEN
Electronic Instrumentation
A7030-AG7030 3kV/ 1mA (1.5W) HV Boards
9
2.
Safety and installation requirements
General safety information
This section contains the fundamental safety rules for the installation and operation of the board. Read thoroughly
this section before starting any procedure of installation or operation of the product.
Injury Precautions
Review the following precautions to avoid injury and prevent damage to this product or any products connected to
it. To avoid potential hazards, use the product only as specified. Only qualified personnel should perform service
procedures.
Avoid Electric Overload.
To avoid electric shock or fire hazard, do not power a load outside of its specified range.
Avoid Electric Shock.
To avoid injury or loss of life, do not connect or disconnect cables while they are connected to a voltage source.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or panels removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electric shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.
Do Not Operate With Suspected Failures.
If you suspect this product to be damaged, have it inspected by qualified service personnel.
Safety Terms and Symbols on the Product
These terms may appear on the product:
DANGER indicates an injury hazard immediately accessible as you read the marking.
WARNING indicates an injury hazard not immediately accessible as you read the marking.
CAUTION indicates a hazard to property including the product.
The following symbols may appear on the product:
DANGER
WARNING
High Voltage
Refer to Manual
Installation
The Mod. A7030
–
AG7030 are SYx527 boards. At power ON the SYSTEM, the processor will scan all the slots in the
crate to find out where the module is plugged and what kind of module it is.
