CAE SimEquip, Getting Started Manual, Page: 44 / 62

Setup
44 ©2021 CAE 905K720652 v1.0
CAE SimEquip
1. Connect the filter to the front panel of the cart where port is labeled EXP . Ensure the filter
ports are closed when the filters are installed.
2. The Anesthesia Machine will require a breathing circuit. To assemble the breathing circuit:
a. Connect plastic cuffs to the end of each breathing circuit limb.
b. Connect one of the limbs to the wye connector (at the y).
c. Connect the opposite limb to the wye connector (at the opposite side of the y).
d. Connect the elbow to the wye connector (at the top of the y).
e. Connect the T-connector to the elbow.
f. Connect the EtCO
2
sample line to the T-connector.
g. Connect the mask or the endotracheal tube to the T-connector (at the open end).
Breathing Circuit Assembled with Non-Invasive Mask
3. Connect the Anesthesia Machine Breathing Circuit to the Medical Cart:
a. Connect one of the tubes to the filter on the front of the Medical Cart.
b. Connect the second tube to the front panel of the Medical Cart port labeled INSP .
c. Attach the EtCO
2
sample line to the front of the Medical Cart by gently twisting the
fitting to secure.
d. Place the breathing circuit limbs inside the articulating arm support.
e. Place the EtCO
2
sample line in the articulating arm support.
4. Attach the SpO
2
probe by aligning the notch and pushing in on the fitting. Wrap the excess
cord around the cord hook on the Medical Cart.
Limbs
Wye
Elbow
T
EtCO
2
Sample
Line
Mask