Cadillac 2002 Eldorado, Manual

Page: 116 / 365

2-59
Your vehicle’s engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Decide which one of the three channels (one of the
HomeLink buttons) you want to program.
2. Press and hold the desired button on HomeLink
through Step 3.
3. When the HomeLink indicator light begins to blink
slowly (this may take up to 30 seconds), hold the
hand
-
held transmitter about 1 to 3 inches (3 to 8 cm)
away from HomeLink and then press and hold the
transmit button on the hand
-
held transmitter.
Continue to hold both buttons until the indicator
light on HomeLink begins to flash rapidly
(this may take up to 90 seconds).
If you have trouble programming HomeLink,
make sure that you have followed the directions
exactly as described and that the battery in the
hand
-
held transmitter is not weak. If you still
cannot program it, move the hand
-
held transmitter
to the left or right or forward or backward or flip it
upside down. HomeLink may not work with older
garage door openers that do not meet current
Federal Consumer Safety Standards. If you cannot
program the transmitter after repeated attempts,
refer to “Training a Garage Door Opener with Rolling
Codes” later in this section or contact the manufacturer
of HomeLink at 1
-
800
-
355
-
3515, or on the internet
at www.homelink.com.
Be sure to keep the original hand
-
held transmitter in
case you need to erase and reprogram HomeLink.