Cadillac 2002 DeVille, Owner'S Manual

Page: 145 / 426

2-77
2. Press the “Learn” or “Smart” button on the garage
door opener motor head unit. An indicator light will
begin to flash when the motor head unit enters the
training mode.
Following this step, you have 30 seconds to
start Step 3.
3. Return to HomeLink in your vehicle and firmly
press and release the programmed HomeLink
button three times.
The rolling
-
code garage door opener should now
recognize HomeLink. You may either use HomeLink or
the hand
-
held transmitter to open the garage door.
If after following these instructions, you still have
problems training the garage door opener, contact the
manufacturer of HomeLink at 1
-
800
-
355
-
3515, or
on the internet at www.homelink.com.
Canadian Programming
Canadian Owners: During programming, the hand
-
held
transmitter may automatically stop transmitting after two
seconds. In this case, you should press and hold the
HomeLink button (see Steps 2 and 3 under
“Programming the HomeLink Transmitter”) while you
press and re
-
press (cycle) your hand
-
held transmitter
every two seconds until HomeLink is trained.
Erasing Channels
To erase all three programmed channels, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Release both buttons.
Resetting Defaults
To reset HomeLink to default settings, hold down the
two outside buttons until the indicator light begins to
flash (approximately 20 seconds). Continue to hold both
buttons until the HomeLink indicator light turns off and
then release both buttons.
Accessories
Accessories for the HomeLink Transmitter are available
from the manufacturer of the unit. If you would like
additional information, please contact the manufacturer
of HomeLink at 1
-
800
-
355
-
3515, or on the internet
at www.homelink.com.