2-57
Programming the Sunroof
If the battery on your vehicle has been recharged,
disconnected or is not working, you will need to
reprogram the sunroof following these steps. Refer to the
illustration under “Sunroof” for control dial positions.
With your vehicle’s ignition on:
1. If the sunroof is closed, turn the control dial to
position E. Hold the dial in position for about
five seconds.
If the sunroof is open, turn the control dial to E and
hold until the glass panel has closed. Now continue
holding the dial for approximately five more seconds.
2. Turn the control dial to position G and hold until the
sunroof is fully tilted (about three seconds after the
motor has stopped).
3. Now turn the control dial to position E and
keep holding until the sunroof is fully closed
(about three seconds after the motor has stopped).
4. Turn the control dial to position A and hold until the
sunroof is fully open (about three seconds after the
motor has stopped).
5. Turn to position E and keep holding the
control dial until the sunroof has fully closed
(about three seconds after the motor has stopped).
The sunroof is now programmed.
Please note that if the sunroof keeps opening after you
attempt to close it once it has been programmed, you
will need to repeat Steps 2 through 5 (up to three times
if needed). If you are still having problems, consult your
dealer for service.
Also keep in mind that if something is in the way of the
sunroof closing during programming and you continue
to program the sunroof, the sunroof will only open or
close to the spot where the obstruction occurred. You
will need to reprogram the sunroof again, making sure
that the object has been removed.
