2 CHANNEL AMP BRIDGED MONO
11
When bridging Cadence two channel
amplifiers, the lowest impedance for the
bridged channel is 4 ohms. Set the crossover
switch to Low Pass and Crossover Frequency
Setting to 100 Hz as a beginning point for
tuning your system. Dial in as much Bass
Drive as necessary keeping in mind that
too much Bass Drive can add unnecessary
distortion to your system.
Utilize the Remote Subwoofer Level control
for bass control from the comfort of your
vehicles interior. You must use the cable
that was supplied with the amplifier for the
remote control. Use of standard phone cables
can short out the amplifier.
If you misplace your cable, please contact us
at 800.477.2328 to procure a replacement or
contact your local Cadence dealer.
SUBWOOFER
MINIMUM IMPEDANCE
4 OHMS
REMOTE SUBWOOFER
LEVEL CONTROL
CROSSOVER MODE
SWITCH IN
LOW PASS
POSITION
CROSSOVER SWITCH
SETTING
Summary of Contents for Flash F100-5
Page 1: ......
