ATENA3 PLUS 12/14 - DUKE 12/14 AIRTIGHT - SABA 12/14 - MITHOS3 PLUS 12/14
12
• Use the arrows to scroll and select “Comfort Mode”
• Press “menu” to confirm.
• Use the + - keys to select “On” (Off by default)
• Press “menu” to confirm and “esc” to exit.
o - Load time-out
You must call a customer service centre to access the technical menu, as it requires a password.
Access the “technical menu” as follows:
• Press the "menu" key.
• Use the arrows to scroll and select "Settings"
• Press “menu” to confirm.
• Use the arrows to scroll and select “Load time-out”
• Press “menu” to confirm.
• Use the + - keys to select “On” (Off by default)
• Press “menu” to confirm and “esc” to exit.
9.5
INFO MENU
• Product Type
• Firmware Version
• Software info
• Total hrs.
• Ignition N.
• Rpm Smoke Fan
• Smoke Temp.
• Air Fan Voltage
• Screw Loading
• Fire
9.6
START UP
We remind you that the first ignition must be carried out by a specialized and authorixed technician who will check that all is
installed in compliance with current regulations and checks the efficiency.
• If inside the combustion chamber there are booklets, manuals, etc..., remove them.
• Check if the door is correctly closed.
• Check if the stove is correctly inserted in the electric socket.
• Before switching the stove on, assure you the burning pot is clean.
• To start the stove, keep the P1 button pressed until the ON sign and a flashing flame to its side appear. The ignition resistance
pre-heating starts. After some seconds the feed screw loads pellets and the resistance pre-heating continues. When the tem-
perature is high enough (after about 5-8 minutes), ignition is considered to be completed.
• Once the ignition step is complete, the stove moves into operating mode and shows the selected heat output, the ambient
temperature and the
big flame
(see
Fig. 8
).
• If the ambient temperature value exceeds the limit set on the button panel in the temperature set, the heat output is brought
to its lowest value and the
small flame
is shown (see
Fig. 9
). When the ambient temperature decreases below the set tem-
perature, the stove goes back to the set output.
Fig. 8 - Big flame
Fig. 9 - Small flame
9.7
FAILED IGNITION
If pellets should not ignite, the lack of ignition will be signalled by the A01 "No Ignition" warning.
If the ambient temperature is below 5°C, the resistance may not heat up enough to guarantee the pallet ignition. In this case,
remove the unburned pellets from the burning pot and restart ignition.
• Too much pellets in the burning pot, or humid pellet, or sooty burning pot make ignition difficult and create dense white
