2
2
2. Safety Information
• The hose and seal on the regulator must be checked for wear or damage
before every use and before connecting to the gas cylinder (see Fig.1).
• Ensure the appliance is used away from flammable materials. Minimum
safe distances are 1.2m above the appliance and 600mm to the rear
and sides of the appliance (see Fig. 2).
• Do not use an appliance that is damaged, leaking, or which does not
operate properly.
• Keep gas cylinders away from heat and flames. Do not place on a stove
or any other hot surface.
• Ensure that the assembled unit is stable and does not rock.
• Do not cover or change the primary air supply openings in the burners
as this will affect the performance of the product and may lead to an
unstable flame.
• In the event of burn back, (where the flame burns back and ignites at
the jet), immediately turn off the gas supply by first closing the control
valve on the gas cylinder and then the appliance valve. After the flame
is extinguished remove the regulator and check the condition of its
seal. Replace the seal if in doubt. Re-light the appliance as described
in Section 3 below. Should the flame light back persistently return the
product to your authorized CADAC repair agent.
• If there is a leak on your appliance (smell of gas), immediately close the
control knob on the gas cylinder. If you wish to check for leaks on your
appliance, do it outside. Do not try to detect leaks using a flame; use
soapy water.
• The correct way is to smear the joints with soapy water. If a bubble or
bubbles form then there is a gas leak. Immediately turn off the gas
supply firstly by closing the control valve on the gas container and then
the appliance valve. Check that all the connections are properly fitted.
Re-check with soapy water. If a gas leak persists, return the product to
your CADAC dealer for inspection / repair.
• Do not modify the appliance or use it for anything which it has not been
designed for.
• During use, part of the appliance will become hot, particularly the
cooking areas and the hood. Avoid touching hot parts with your bare
hands. The use of oven gloves is recommended.
• Keep young children away from the appliance at all times.
• This appliance consumes oxygen and needs ventilation for optimum
performance and for the safety of those in close proximity.
Use
Outdoors Only!
• Do not move the appliance while in use.
• The parts sealed by the manufacturer or its agent must not be altered
by the user.
NOTE
• Do not twist or pinch the hose. Ensure that it is kept away from the
BBQ body so as to prevent deterioration/damage to the hose caused by
heat.
• Fit one end of the low pressure hose onto the regulator nozzle. Thread
the other end from inside cabinet, through the hole on the left side
panel, onto the Patio BBQ nozzle. Push the ends on as firmly as
possible. Clamp them into position using hose clamps at both ends of
the hose.
• Ensure that the connections are made securely and do not allow gas to
leak.
• Check for gas leaks before using the appliance.
• For use with an approved hose and regulator connected to a refillable
gas container not exceeding 9kg and complying with local regulation in
force.
• Do not obstruct the ventilation openings of the cabinet.
• Do not modify the appliance. Modifying the appliance may be
dangerous.
•
Warning:
An LP cylinder not connected for use shall not be stored in the
vicinity of this or any other appliance.
Fig. 2
Fig. 3
Fig. 1
Seal
Cylinder Valve
Fit hose clamp
here
Regulator
Hose
