Installing the Bridle
7)
Thread the cross bridle lines through the 3 pulleys located on the
leading edge of the kite. Start at the wing tip and move toward
the center of the kite.
8)
Do this on each side.
9)
Take the blue cross bridle line and using the larks head at the
end, slide it onto the red rear line until you reach the 3 knots in
the middle of the red line.
10)
Tighten the larks head behind knot 2 from the cluster end.
11)
Do this on the other side.
12)
Utilizing the larks head, attach the rear line to the rear line hang
point (near the inflated strut). Make sure that the blue rear line is
on the kite’s right rear hang point and the red rear line is on the
kite’s left.
13)
Your CO2 is now ready to be flown as a 2-line kite.
2 TO 4-LINE CONVERSION
CO2
CONT’
