CONTROLLING YOUR DEVICES
1.
Turn on your Device (TV or Audio Amp)
2.
Locate the brand and a 5- digit code for your Device at the setup code list included at the end of
this document.
3.
Press
MODE
until the feedback LED of the device you want to program lights.
4.
Press and hold
MUTE
and
SELECT
at the same time until the green light flashes twice.
5.
Using the number keys enter the 5-digit code for your brand of TV. If performed correctly, the
green light flashes twice.
6.
Aim the remote at your TV and press
VOL or MUTE
key once. Your TV should ramp up or down
or MUTE. If Volume does not change, repeat steps 3 and 5, trying each code for your brand until
you find the correct code.
Activating RF
To pair the FLOW remote control to the STB, perform the following steps:
1.
Press and HOLD
PLAY/PAUSE
and
MUTE
at the same time until the Feedback LED light flashes
twice.
2.
If the pairing is successful the Feedback LED will blink two times.
Note:
if you get one long blink means the paring sequence fails, please try again since step 1
Deactivating RF
To deactivate the RF Transmitter on the DIRECTV remote control, perform the following steps:
1.
Press and hold
MUTE
and
EXIT
at the same time until the green light flashes twice.
2.
If the pairing is successful the Feedback LED will blink four times.
Note:
if you get one long blink means the paring sequence fails, please try again since step 1
RESTORING FACTORY DEFAULT SETTINGS
To reset all the functions of the remote control to the factory default settings following these steps:
1.
Press and hold
MUTE
and
SELECT
at the same time until the green light flashes twice.
2.
Using the number keys, enter
9-7-7
. (The green light flashes 4 times).
