INSTALLATION
2-10
3.
Attach the lobe cable to the STATION port DB9 connector on the
TRMM-2 faceplate. When connecting with UTP cable, use a TRMF-2
media filter (as shown in
Figure 2-7
).
4.
Attach the other end of the cable to the selected Token Ring LAN
using any concentrator lobe port assigned to the destination ring
(for example, a TRXMIM lobe port that is assigned to
FNB Ring 2).
Figure 2-7 Attaching A Cable To The STATION Port Interface Using A
TRMF-2 Media Filter
2.7 CONFIGURING THE TRMM-2 USING LM
This section provides a quick reference for LM configurations to
complete the installation. Detailed instructions are provided in the
TRMM-2 Local Management User’s Guide.
NOTE
The length of the STATION port interface cable is limited by the
device to which it is attached. Consult the documentation for
that device for information about lobe lengths.
TRMM-2
SN
TOKEN RING
RESET
S
T
A
T
I
O
N
R
I
N
G
1
C
O
M
1
C
O
M
2
TRMF-2
802.5 MEDIA FILTER
Summary of Contents for TRMM-2
