6C110 Power Bridge Adapter Installation Instructions
9033011
Page 2 of 7
Installing the Power Bridge Adapter
This section provides instructions on installing the power bridge adapter to allow the 6C110 chassis to support the
6C210-1 or 6C210-2 power supplies. If the legacy 6C205-2 or 6C205-3 power supplies will be used, DO NOT
install the power bridge adapter.
To install the power bridge adapter, perform the following steps:
1. Attach the ESD wrist strap.
2. Refer to Figure 1 to identify the front and rear sides of the power bridge adapter.
Figure 1 Power Bridge Adapter (Front and Back)
!
CAUTION
These instructions apply to users that will equip the 6C110 chassis with 6C210-1 or
6C210-2 power supplies. If legacy 6C205-2 or 6C205-3 power supplies will be used, DO
NOT install the power bridge adapter.
All Cabletron Systems interface modules are sensitive to static discharges. Use an ESD
wrist strap and observe all static precautions during this procedure. Failure to do so could
damage the backplane of the 6C110.
Power Bridge Adapter
(Front, White Connectors)
Power Bridge Adapter
(Rear, Black Connectors)
