background image

 

6C110 Power Bridge Adapter Installation Instructions

9033011

Page 7 of 7

 

Getting Help

 

For additional support related to this device or document, contact Cabletron Systems using one of the following 
methods:

 

Before calling Cabletron Systems, have the following information ready:

 

Your Cabletron Systems service contract number 

A description of the failure

A description of any action(s) already taken to resolve the problem (e.g., changing mode switches, rebooting the 
unit, etc.)

The serial and revision numbers of all involved Cabletron Systems products in the network

A description of your network environment (layout, cable type, etc.)

Network load and frame size at the time of trouble (if known)

The device history (i.e., have you returned the device before, is this a recurring problem, etc.)

Any previous Return Material Authorization (RMA) numbers

 

 

 1999 by Cabletron Systems, Inc., P.O. Box 5005, Rochester, NH 03866-5005

All Rights Reserved
Printed in the United States of America

Order Number: 9033011 February 1999

 

Cabletron Systems

 

 is a registered trademark and 

 

SmartSwitch

 

 is a trademark of Cabletron Systems, Inc.

 

World Wide Web

http://www.cabletron.com/ 

Phone

(603) 332-9400

Internet mail

[email protected]

FTP

ftp://ftp.cabletron.com/

Login 

 

anonymous

 

Password 

 

your email address

 

To send comments or suggestions concerning this document, contact the 
Cabletron Systems Technical Writing Department via the following 
email address:

 

[email protected]

 

Make sure to include the document Part Number in the email message.

Summary of Contents for SmartSwitch 6C110








Reviews: