Cabletron Systems SmartSTACK ELS100-S24TX2M, Management Manual

Page: 54 / 102

54 ELS100-S24TX2M User Interface ELS100-S24TX2M
802.1Q VLAN Current Table Information
This screen shows the current port members of each VLAN and whether
or not the port supports VLAN tagging. Ports assigned to a large VLAN
group that crosses several switches should use VLAN tagging. However,
if you just want to create a small port-based VLAN for one or two switches,
you can assign ports to the same untagged VLAN (page 57). The current
configuration is shown in the following figure.
Figure 2-34. 802.1Q VLAN Current Table Information
Parameter Description
Deleted VLAN Entry
Counts The number of times a VLAN entry has been deleted from this
table.
VID The ID for the VLAN currently displayed.
Creation Time The value of sysUpTime (System Up Time) when this VLAN was
created.
Status Shows how this VLAN was added to the switch:
Dynamic GVRP: Automatically learned via GVRP.
Permanent:
Added as a static entry.
Unit Stack unit.
Current Egress Ports Shows the ports which have been added to the displayed VLAN
group, where “1” indicates that a port is a member and “0” that it
is not.
Current Untagged
Ports If a port has been added to the displayed VLAN (see Current
Egress Ports), its entry in this field will be “1” if the port is
untagged or “0” if tagged.
[Show] Displays the members for the VLAN indicated by the “Sorted by
VID” field.
[More] Displays any subsequent VLANs if configured.
SmartSTACK Local Management -- ELS100-S24TX2M
802.1Q VLAN Current Table Information
Deleted VLAN Entry Counts : 0
VID Creation Time Status
--------------------------------------------------------------------------------
1 0 (0 day 0 hr 0 min 0 sec) Dynamic GVRP
Unit Current Egress Ports Current Untagged Ports
1. 100000000000 100000000000 10 100000000000 000000000000 00
2. ------------ ------------ --
------------ ------------ --
3. ------------ ------------ -- ------------ ------------ --
4. ------------ ------------ -- ------------ ------------ --
Sorted by VID : 1
[Show] [More]
<OK>
Use <TAB> or arrow keys to move. < Enter> to select.
Port 1 Port 13 Port 25